Automatic Turntable Pallet Stretch Wrapper
Automatic turntable pallet wrapper has auto film clamp and cut unit on turntable. Remote control is available for better automation.
Automatic turntable wrapper can be designed with flat turntable or turntable with motorized rollers. The complete wrapping and film cutting is finished automatically.
Automatic turntable pallet wrapper is integrated into conveying system for high speed wrapping system. It has auto film clamp and cut unit on turntable. Remote control is available for better automation.
Automatic turntable wrapper can be designed with flat turntable or turntable with motorized rollers. The complete wrapping and film cutting is finished automatically.
Technology data:
Max load size(mm) | 1000 (L)×1200(W)×2400(H)mm |
Packing efficiency | 0-35 loads / hour |
Rotating turntable speed | 3-15rpm |
Height of turntable | 500mm |
Power supply | 380V 50HZ 3Phase |
Max load capacity | 2000kgs |
Wrapping requirement | wrapping bottom (start/finish) height can be adjustable from 90mm |
Working ambiance | Indoor, normal temperature |
Turntable | Diameter: 1800mm |
Mast height | 3300mm (to be designed) |
Wrapping material
Utility:
Compressed air
Pressure: 0.5-0.6 MPa
Dew point: +2-+10℃ (7bar, +2-+10℃)
Air consumption: 1000ml/min
Supply scope
Rotating turntable
Turntable diameter: 2000mm
Turntable height: 500mm from floor
Roller dia.: 76mm, galvanized
Slew bearing driven
Mast with film carriage
Open-door type film carriage, pre-stretch up to 250% (1m to 3.5m)
Film carriage lifting driving: chain driving, good stability and high reliability
Driving reducer: worm gear reducer
Open-door type film carriage
Film carriage and film delivery motor: SEW brand; power: 0.37kw
Film feeding & cutting device
When stretch wrapping finish, the film will be cut and clamped automatically.
When the film tail is released from the clamp, the air shooter will blow the film tail up, then the film tail will be wrapped by stretch film and keep it tightly with the pallet to ensure no film tail produced.
Film hot melt cutting adopts electrical heating wire to cut the film.
After film being cut, the brush goes onto the film tail to make it smooth.
Control system
PLC control system with touch screen, 8 sets of parameter settings available
Cut film automatically after wrapping finished
Film tension control adjustable; Carriage up/down speed adjustable
Safety tower light alarm
E-Stop button, relay, lockable ON/OFF switch included for deactivate every form of energy
Wrap/no wrap selector switch on the cabinet for pallet by-pass.
